LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount-To-Frame Bracket Bolts (Right)
    GM794678Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine mount-to-frame bracket bolts. (Right side shown, left side similar).
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 2: Engine Protection Shield
    GM794711Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine shield bolts.
  4. Remove the engine shield.
    IMPORTANT: DO NOT raise and/or support the engine by the crankshaft balancer, or oil pan.
  5. Raise and suitably support the engine using adjustable (screw type) jack stands.
    6. Fig 3: Engine Mount (Left)
    GM794679Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine mount bolts.
  7. Remove the engine mount.
scientia non olet · About LEMON Manuals