LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount (Left)
    GM794679Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Position the engine mount to the engine.
  2. Install the engine mount bolts.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

  3. Lower the engine.
  4. Remove the adjustable jack stands.
    5. Fig 2: Engine Protection Shield
    GM794711Courtesy of GENERAL MOTORS CORP.
  5. Position the engine shield to the vehicle.
  6. Install the engine shield bolts.

    Tighten:  Tighten the engine shield bolts to 30 N.m (22 lb ft).

  7. Lower the vehicle.
    8. Fig 3: Engine Mount-To-Frame Bracket Bolts (Right)
    GM794678Courtesy of GENERAL MOTORS CORP.
  8. Install the engine mount-to-frame bracket bolts (right side shown, left side similar).

    Tighten:  Tighten the engine mount-to-frame bracket bolts to 65 N.m (48 lb ft).

scientia non olet · About LEMON Manuals