LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Bracket Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount Bracket (Right)
    GM794681Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount bracket.
  2. Perform the following procedure prior to installing the engine mount bracket bolts.
    • Remove all traces of the original adhesive patch.
    • Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    • Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
    3. NOTE: Refer to Fastener Notice .
  3. Install the engine mount bracket bolts.

    Tighten:  Tighten the engine mount bracket bolts to 75 N.m (55 lb ft).

  4. Install the engine mount. Refer to Engine Mount Replacement - Right Side .
scientia non olet · About LEMON Manuals