LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Flywheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Flywheel & Bolt
    GM178458Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the position and direction of the engine flywheel before removal.
  1. Remove the automatic transmission. Refer to Transmission Replacement .
  2. Remove the engine flywheel bolts.
  3. Remove the automatic transmission engine flywheel.
    4. Fig 2: View Of Bolts & Spacer
    GM642281Courtesy of GENERAL MOTORS CORP.
  4. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 3: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS CORP.
  6. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals