Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Route the drive belt around all the pulleys except the idler pulley.
- Install the breaker bar with hex-head socket to the belt tensioner bolt.
- Rotate the belt tensioner clockwise in order to relieve the tension on the tensioner.
- Install the drive belt under the idler pulley.
- Slowly release the tension on the belt tensioner.
- Remove the breaker bar and socket from the belt tensioner bolt.
- Inspect the drive belt for proper installation and alignment.
- Install the air cleaner outlet duct.
- Tighten the air cleaner outlet duct clamps at the following locations:
- Throttle body
- MAF/IAT sensor
Tighten: Tighten the air cleaner outlet duct clamp screws to 7 N.m (62 lb in).
IMPORTANT:
Align the arrow at the throttle body end of the duct with the throttle body attaching stud.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.