LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Idler Pulley
    GM678804Courtesy of GENERAL MOTORS CORP.
  1. Loosen the drive belt idler pulley bolt.
  2. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  3. Remove the drive belt idler pulley and bolt.
scientia non olet · About LEMON Manuals