LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Compressor Belt Replacement - Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of A/C Belt & Pulleys
    GM370869Courtesy of GENERAL MOTORS CORP.
  1. Install the A/C belt around the crankshaft balancer.
  2. Install a ratchet into the A/C drive belt tensioner adapter opening
  3. Rotate the A/C belt tensioner clockwise in order to relieve tension on the tensioner.
  4. Install the A/C belt over the idler pulley.
  5. Install the A/C belt around the A/C compressor pulley.
  6. Slowly release the tension on the A/C belt tensioner.
  7. Remove the ratchet from the A/C belt tensioner.
  8. Inspect the A/C belt for proper installation and alignment.
  9. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    10. Fig 2: Drive Belt
    GM678802Courtesy of GENERAL MOTORS CORP.
  10. Install the engine shield bolts.

    Tighten:  Tighten the engine shield bolts to 20 N.m (15 lb ft).

  11. Lower the vehicle.
  12. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals