LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm and Push Rod Removal

Valve Rocker Arm and Push Rod Removal

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Place the valve rocker arms, valve pushrods, and pivot support in a rack so that they can be installed in the same location from which they were removed.
    Fig 1: View Of Rocker Arms & Bolts
    GM260140Courtesy of GENERAL MOTORS CORP.
  1. Remove the valve rocker arm bolts.
  2. Remove the valve rocker arms.
    3. Fig 2: View Of Valve Rocker Arm Pivot Support
    GM260141Courtesy of GENERAL MOTORS CORP.
  3. Remove the valve rocker arm pivot support.
    4. Fig 3: View Of Pushrods
    GM260142Courtesy of GENERAL MOTORS CORP.
  4. Remove the pushrods.
scientia non olet · About LEMON Manuals