Valve Rocker Arm Cover Installation - Right Side

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Fill Cap & Tube

Courtesy of GENERAL MOTORS CORP.

IMPORTANT:

All gasket surfaces should be free of oil or other foreign material during assembly.
Do not use the valve rocker arm cover gasket again.
Do not remove the ignition coils and bracket from the valve rocker arm cover, unless required.
The valve rocker arm cover bolt grommets may be used again.
If the oil fill tube has been removed from the valve rocker arm cover, install a NEW oil fill tube during assembly.

Lubricate the O-ring seal of the NEW oil fill tube with clean engine oil.
Insert the NEW oil fill tube into the rocker arm cover and rotate the tube clockwise until locked in the proper position.
Install the oil fill cap into the tube and rotate clockwise until locked in the proper position.

Fig 2: View Of Valve Rocker Arm Cover Gasket

Courtesy of GENERAL MOTORS CORP.

Install a NEW cover gasket (504) into the right valve rocker arm cover.

Fig 3: View Of Valve Rocker Arm Cover & Bolts (Right)

Courtesy of GENERAL MOTORS CORP.

Install the valve rocker arm cover onto the cylinder head.

NOTE: Refer to Fastener Notice .

Install the cover bolts with grommets.
Tighten: Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

Fig 4: View Of Ignition Coil, Bracket Assembly & Bolts (Right)

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the bracket studs.
Install the ignition coil and bracket assembly and studs.
Tighten: Tighten the ignition coil and bracket assembly studs to 12 N.m (106 lb in).