Valve Rocker Arm Cover Installation - Left Side

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Valve Rocker Arm Cover Gasket

Courtesy of GENERAL MOTORS CORP.

IMPORTANT:

All gasket surfaces should be free of oil or other foreign material during assembly.
DO NOT use the valve rocker arm cover gasket again.
The valve rocker arm cover bolt grommets may be used again.
If the vapor vent grommet has been removed from the valve rocker arm cover, install a NEW vapor vent gourmet during assembly.

Install a NEW cover gasket (504) into the left valve rocker arm cover.

Fig 2: View Of Valve Rocker Arm Cover

Courtesy of GENERAL MOTORS CORP.

Install the valve rocker arm cover onto the cylinder head.

NOTE: Refer to Fastener Notice .

Install the cover bolts with grommets.
Tighten: Tighten the valve rocker arm cover bolts to 12 N.m (106 lb in).

Fig 3: View Of Ignition Coil, Bracket Assembly, Wire Harness & Bolts (Left)

Courtesy of GENERAL MOTORS CORP.

Apply threadlock GM P/N 12345382 (Canadian P/N 10953489), or equivalent, to the threads of the bracket studs.
Install the ignition coils and bracket assembly and studs.
Tighten: Tighten the ignition coil and bracket assembly studs to 12 N.m (106 lb in).