Piston and Connecting Rod Disassemble

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Piston, Connecting Rod & Bearing Assembly

Courtesy of GENERAL MOTORS CORP.

Remove the connecting rod bearings from the rod and cap.

Fig 2: Removing/Installing Piston Rings

Courtesy of GENERAL MOTORS CORP.

Using piston ring pliers, remove the piston rings from the piston.

Fig 3: View Of Piston Pin Retaining Clip & Cutout Area Of Pin Bore

Courtesy of GENERAL MOTORS CORP.

Rotate the piston pin retainers until the ring end gaps are positioned in the cutout area (1) of the pin bore.

Fig 4: Piston Pin Retainer

Courtesy of GENERAL MOTORS CORP.

Remove the retainers starting in the cutout area of the pin bore.

Fig 5: Piston Pin, Piston & Connecting Rod

Courtesy of GENERAL MOTORS CORP.

Remove the pin from the piston and connecting rod.
The piston and pin are a matched set and are not to be serviced separately.
Mark, sort, or organize the piston and the matching piston pin.