LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Valley Cover Removal

Engine Valley Cover Removal

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Knock Sensor Wire Harness
    GM309859Courtesy of GENERAL MOTORS CORP.
  1. Remove the knock sensor wire harness.
    2. Fig 2: View Of Knock Sensors
    GM309864Courtesy of GENERAL MOTORS CORP.
  2. Remove the knock sensors.
    3. Fig 3: View Of Engine Valley Cover, Gasket & Bolts
    GM65048Courtesy of GENERAL MOTORS CORP.
  3. Remove the valley cover bolts.
  4. Remove the valley cover and gasket.
  5. Discard the valley cover gasket.
    6. Fig 4: View Of Knock Sensor Oil Seals & Valley Cover
    GM1277106Courtesy of GENERAL MOTORS CORP.
  6. Remove the knock sensor oil seals (520) from the cover (555).
scientia non olet · About LEMON Manuals