LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft and Bearings Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Crankshaft
    GM156153Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use care when handling the crankshaft. Avoid damage to the bearing surfaces or the lobes of the crankshaft position reluctor ring. Damage to the teeth of the crankshaft position (CKP) reluctor ring may affect on-board diagnostics (OBD) II system performance.
  1. Clean the crankshaft with solvent.
  2. Thoroughly clean all oil passages and inspect for restrictions or burrs.
    3. CAUTION: Refer to Safety Glasses Caution .
  3. Dry the crankshaft with compressed air.
scientia non olet · About LEMON Manuals