LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Coolant Air Bleed Pipe Removal

Coolant Air Bleed Pipe Removal

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Coolant Air Bleed Pipe, Bolt & Gasket
    GM1277099Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine coolant air bleed pipe bolts (309).
  2. Remove the pipe (307) with hose and seals (308).
    3. Fig 2: View Of Engine Coolant Air Bleed Cover, Gasket & Bolts
    GM1272806Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine coolant air bleed cover bolts (312), covers (313), and seals (308).
    4. Fig 3: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
  4. Remove the seals (308) from the pipe and covers.
  5. Discard the seals.
    6. Fig 4: View Of Engine Coolant Air Bleed Pipe, Hose & Clamps
    GM1277104Courtesy of GENERAL MOTORS CORP.
  6. Remove the hose (311) and clamps (310) from the pipe (307).
scientia non olet · About LEMON Manuals