Fastener Tightening Specifications
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Catalytic Converter-to-Muffler Flange Nut | 48 N.m | 35 lb ft |
| Engine Protection Shield Bolt | 20 N.m | 15 lb ft |
| Exhaust Heat Shield Nut (Body Panel) | 9 N.m | 80 lb in |
| Exhaust Manifold Bolts | ||
|
15 N.m | 11 lb ft |
|
25 N.m | 18 lb ft |
| Exhaust Manifold Heat Shield Bolt | 9 N.m | 80 lb in |
| Exhaust Manifold Pipe Nut | 50 N.m | 37 lb ft |
| Exhaust Muffler Nut | 40 N.m | 30 lb ft |
| Exhaust Pipe Clamp | 40 N.m | 30 lb ft |
| Exhaust Pipe Hanger Bracket Bolt | 12 N.m | 106 lb in |
| Lower Stabilizer Bar Nut | 72 N.m | 53 lb ft |
| Oxygen Sensor | 42 N.m | 31 lb ft |
| Rear Shock Absorber Lower Bolt/Nut | 105 N.m | 77 lb ft |
| Rear Track Bar Bolt/Nut | 105 N.m | 77 lb ft |
| Transmission Bolt | 100 N.m | 74 lb ft |