LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Exhaust) >> Repair Instructions >> Exhaust Manifold Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exhaust Manifold Pipe Nuts (Right)
    GM664837Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the exhaust manifold pipe nuts.
  3. Lower the vehicle.
  4. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  5. Drain the coolant. Refer to Draining and Filling Cooling System .
  6. Using the J 43181  , remove the heater core hoses from the heater core. Position aside.
  7. Remove the spark plug wires. Refer to Spark Plug Wire Replacement .
  8. Remove the oil level indicator tube. Refer to Oil Level Indicator and Tube Removal .
    9. Fig 2: Exhaust Manifold Bolts, Manifold & Manifold Gasket (Right)
    GM260093Courtesy of GENERAL MOTORS CORP.
  9. Remove the exhaust manifold bolts, manifold, and manifold gasket.
  10. Discard the gasket.
    11. Fig 3: View Of Heat Shield Bolts, And Shield From The Exhaust Manifold (4.8L, 5.3L, and 6.0L Engines)
    GM492768Courtesy of GENERAL MOTORS CORP.
  11. Remove the heat shield bolts (3), and shield (2) from the exhaust manifold (1).
  12. Clean and inspect the exhaust manifold. Refer to Exhaust Manifold Cleaning and Inspection .
scientia non olet · About LEMON Manuals