LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Engine Exhaust) >> Repair Instructions >> Exhaust Heat Shield Replacement - Dash Panel >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left Exhaust Heat Shield & Nuts
    GM707396Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the exhaust heat shield to the dash panel studs (1), (3).
  2. Install the exhaust heat shield nuts.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  3. Install the engine protection shield and bolts. Refer to Engine Protection Shield Replacement .

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals