LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Propeller Shaft) >> Repair Instructions >> Rear Propeller Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of lubricant. If the splines of the slip yoke does not have a sufficient coating of lubricant, lubricate the shaft with lubricant GM P/N 12345879 (Canadian P/N 10953511) or with an equivalent lubricant meeting GM specification 9985830.
    2. Fig 1: View Of Propeller Shaft To Transmission Or Transfer Case
    GM404287Courtesy of GENERAL MOTORS CORP.
  2. Install the propeller shaft into the transfer case.

    Align the reference marks made during removal.

    3. Fig 2: Identifying Driveshaft Pinion, Yoke Retainers & Bolts
    GM361391Courtesy of GENERAL MOTORS CORP.
  3. Install the propeller shaft (3) to the rear axle pinion yoke (4).

    Align the reference marks made during removal.

    4. NOTE: Refer to Fastener Notice .
  4. Install the yoke retainers (2) and bolts (1).

    Tighten:  Tighten the yoke retainer bolts to 25 N.m (18 lb ft).

  5. Lower the vehicle.
scientia non olet · About LEMON Manuals