LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Windshield Pillar Garnish Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Assist Handle
    GM922456Courtesy of GENERAL MOTORS CORP.
  1. Using a suitable flat bladed tool, release the retaining tabs and remove the assist handle.
  2. Rotate the windshield garnish molding inboard to disengage the retaining tab, then rotate rearward to remove from vehicle.
  3. Disconnect the speaker connector.
  4. Remove the windshield garnish molding from the vehicle.
scientia non olet · About LEMON Manuals