LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Windshield Pillar Garnish Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Assist Handle
    GM922456Courtesy of GENERAL MOTORS CORP.
  1. Install the windshield garnish molding to the vehicle.
  2. Connect the speaker connector.
  3. Rotate the windshield garnish molding forward and outboard to engage the retaining tab.
  4. Install the assist handle and press in the retaining tabs.
scientia non olet · About LEMON Manuals