LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Upper Garnish Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Upper Garnish Molding
    GM922459Courtesy of GENERAL MOTORS CORP.
  1. Firmly grasp the retaining fasteners and pull gently in order to disengage the fasteners.
  2. Remove the garnish molding from the vehicle.
  3. Inspect for broken or missing fasteners. Replace the fasteners as necessary before installation
scientia non olet · About LEMON Manuals