LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Upper Garnish Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Upper Garnish Molding
    GM922459Courtesy of GENERAL MOTORS CORP.
  1. Align the garnish molding with the openings in the body.
  2. Install the retaining fasteners through the garnish molding.
  3. Press gently to fully engage the fasteners.
scientia non olet · About LEMON Manuals