LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Side Door Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Side Rear Door Trim Panel
    GM922455Courtesy of GENERAL MOTORS CORP.
  1. Remove the upper door trim panel. Refer to Upper Extension Trim Panel Replacement .
  2. Remove the rear door handle bezel. Refer to Rear Door Inside Handle Bezel Replacement .
  3. Remove the door panel retaining screw located in the handle bezel opening.
  4. Use J 38778  to release the retaining clips from the door trim panel. See Special Tools .
  5. Disconnect the electrical wiring harness connectors.
  6. Remove the door trim panel from the vehicle.
  7. Inspect for missing or broken retaining fasteners. Replace the fasteners as necessary.
scientia non olet · About LEMON Manuals