LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Compartment Side Trim Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the spare tire carrier to the full open position.
  2. Open the endgate.
  3. Remove the right rear sail panel molding. Refer to Sail Panel Molding Replacement (Left Side) .
  4. Open the midgate.
  5. Release the exterior midgate weatherstrip up to the stationary opera quarter window.
  6. Remove the bolts securing the rear floor cargo liner tie down loops to the body.
  7. Remove the bolts, loops and floor liner from the vehicle.
  8. Unlock and open the jack stowage lid.
    9. Fig 1: RH Rear Compartment Side Trim Panel
    GM1427865Courtesy of GENERAL MOTORS CORP.
  9. Release the hook and loop attachment (1) for the jack handles (2) at the front of the jack stowage box.
  10. Remove the jack handles.
    11. Fig 2: Rear Hook And Loop And Attachment Bolt
    GM1427868Courtesy of GENERAL MOTORS CORP.
  11. Remove the bolts (2) securing the hook and loop attachment at the rear of the jack stowage box.
  12. Remove the nut securing the wheel blocks to the jack plate.
  13. Remove the wheel blocks from the jack stowage compartment.
  14. Remove the nut securing the jack to the jack plate.
    15. Fig 3: Removing/Installing The Jack
    GM1428111Courtesy of GENERAL MOTORS CORP.
  15. Remove the jack (1).
    16. Fig 4: Jack Plate
    GM1428079Courtesy of GENERAL MOTORS CORP.
  16. Remove the nuts (3, 4) securing the jack plate (2) to the stowage box.
  17. Remove the jack plate (2).
  18. Remove the cap, nut and washer securing the inflator line to the rear accessory power outlet.
    19. Fig 5: Releasing Bottom Edge Of The Accessory Power Outlet
    GM1427914Courtesy of GENERAL MOTORS CORP.
  19. With a flat-bladed tool, release the bottom edge of the accessory power outlet.
  20. Release the accessory power outlet from the right hand compartment side trim panel.
    21. Fig 6: Accessory Outlet Panel
    GM1427870Courtesy of GENERAL MOTORS CORP.
  21. Disconnect the inflator switch electrical connector (3).
  22. Remove the inflator line (2).
  23. Disconnect the electrical connector (7) for the 12-volt accessory outlet.
  24. Remove the accessory outlet panel (8) from the right hand compartment side trim panel.
  25. Remove the right hand rear compartment side trim panel from the pickup box.
scientia non olet · About LEMON Manuals