LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Rear Compartment Side Trim Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the right hand rear compartment side trim panel to the pickup box.
    2. Fig 1: Accessory Outlet Panel
    GM1427870Courtesy of GENERAL MOTORS CORP.
  2. Position the accessory outlet panel (8) to the right hand compartment side trim panel.
  3. Insert the inflator line into the accessory outlet box.
  4. Loosely install the washer and nut to the inflator line.
  5. Connect the electrical connectors to the inflator switch (4) and the 12-volt power outlet (5) electrical connectors.
  6. Position the right hand compartment side trim panel into vehicle position over the jack stowage plate studs.
    7. Fig 2: Jack Plate
    GM1428079Courtesy of GENERAL MOTORS CORP.
  7. Install the jack plate (2) to the jack stowage box.
    8. NOTE: Refer to Fastener Notice .
  8. Install the nuts (3, 4).

    Tighten:  Tighten the nuts to 50 N.m (37 lb ft).

    9. Fig 3: Rear Hook And Loop And Attachment Bolt
    GM1427868Courtesy of GENERAL MOTORS CORP.
  9. Install the rear hook and loop and attachment bolt (2) to the rear inner compartment side panel.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    10. Fig 4: RH Rear Compartment Side Trim Panel
    GM1427865Courtesy of GENERAL MOTORS CORP.
  10. Install the front hook and loop and the attachment bolt (1) to the front inner compartment side panel.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    11. Fig 5: Removing/Installing The Jack
    GM1428111Courtesy of GENERAL MOTORS CORP.
  11. Install the jack (1) to the jack plate.
  12. Hand-tighten the nut to secure the jack to the jack plate.
  13. Install the wheel blocks to the jack plate.
  14. Hand-tighten the wheel blocks nut.
  15. Tighten the inflator line nut.

    Tighten:  Tighten the inflator line nut to 10 N.m (89 lb in).

  16. Install the inflator line cap.
  17. Position the top side of the accessory outlet panel to the right hand compartment side panel.
  18. Push inward at the bottom edge in order to secure.
  19. Close the accessory outlet lid.
  20. Secure the jack handles (3) to the hook and loop attachment straps.
  21. Close the jack stowage lid and secure the lock.
  22. Install the rear floor cargo liner.
  23. Install the rear floor cargo liner tie down loops.
  24. Install the bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  25. Reposition the midgate weatherstrip onto the pinch-weld flange over the front edge of the floor liner and front edge of the right side compartment trim panel.
  26. Close the midgate.
  27. Install the right rear sail panel molding. Refer to Sail Panel Molding Replacement (Left Side) .
  28. Close the endgate.
  29. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals