LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Midgate Hinge Finish Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Midgate Hinge Trim Cover
    GM1486639Courtesy of GENERAL MOTORS CORP.
  1. Insert a flat-bladed tool at the top of the midgate hinge cover trim (2), between the midgate (1) and the trim cover (2) tab.
  2. Push up on the flat-bladed tool to release the midgate hinge trim cover (2) tab.
    3. Fig 2: Seat Belt Anchor
    GM1486642Courtesy of GENERAL MOTORS CORP.
  3. Once the midgate hinge trim cover (1) tab is released, roll the midgate hinge trim cover (1) forward.
  4. Lift the hinge trim cover (1) up, in order to remove the midgate hinge trim cover off the hinge pin.
scientia non olet · About LEMON Manuals