LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Lock Pillar Upper Garnish Molding Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lock Pillar Garnish Molding
    GM1453839Courtesy of GENERAL MOTORS CORP.
  1. Remove the center pillar upper garnish molding. Refer to Center Pillar Upper Garnish Molding Replacement .
  2. Carefully pull the lock pillar garnish molding (1) towards the front of the vehicle, only far enough to release the rearward facing clips.
  3. Pull the lock pillar garnish molding (1) away from the body towards the center of the vehicle to release the remaining clips.
  4. Remove the lock pillar garnish molding (1).
scientia non olet · About LEMON Manuals