Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Align the lock pillar garnish molding (1) with the body.
- Push the lock pillar garnish molding (1) towards the outside of the body to engage clips.
- Push the lock pillar garnish molding (1) towards the rear of the vehicle to engage the remaining clips.
- Install the lock pillar garnish molding (1). Refer to Center Pillar Upper Garnish Molding Replacement .
IMPORTANT:
Ensure the molding clips are aligned with the openings in the body before pushing on the panel to engage the molding clips.