Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Liftgate Trim Panel

Courtesy of GENERAL MOTORS CORP.

If the vehicle is equipped with tie downs and the service replacement part does not have the down holes, drill out the etched holes on the rear of the liftgate panel.
Install the lift gate trim panel to the vehicle on the liftgate trim panel.
1. Align the retaining clips on the liftgate trim panel with the openings in the lift gate.
2. Gently press inward on the liftgate trim panel to engage the clips.

Fig 2: Cargo Tie Down

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the cargo tie down and secure with the tie down bolt.
Tighten: Tighten the bolt to 9 N.m (80 lb in).
Install the lift gate pullstrap. Refer to Liftgate Pull Strap Replacement .
Install the 2 push pin fasteners at the bottom edge of the liftgate trim panel.