LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Endgate Center Molding Replacement (SUT) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Belt Anchor
    GM1486642Courtesy of GENERAL MOTORS CORP.
  1. Fold the rear seats forward.
  2. Remove the rear folding seat back covers. Refer to Seat Back Cover Replacement - Rear Folding .
  3. Remove the midgate hinge cover trim (1). Refer to Midgate Hinge Finish Cover Replacement .
    4. Fig 2: Endgate Center Molding
    GM1486635Courtesy of GENERAL MOTORS CORP.
  4. Pull the endgate center molding (1) towards the front of the vehicle to release the clips.
  5. Remove the endgate center pillar molding.
scientia non olet · About LEMON Manuals