LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Endgate Center Molding Replacement (SUT) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Endgate Center Molding
    GM1486635Courtesy of GENERAL MOTORS CORP.
  1. Position the endgate center molding (1) to the body and align the clips to the body.
  2. Push the endgate center molding (1) towards the rear of the vehicle to engage the molding clips.
    3. Fig 2: Seat Belt Anchor
    GM1486642Courtesy of GENERAL MOTORS CORP.
  3. Install midgate hinge trim cover (1). Refer to Midgate Hinge Finish Cover Replacement .
  4. Install the rear folding seat back covers. Refer to Seat Back Cover Replacement - Rear Folding .
  5. Restore the rear seats to the upright position.
scientia non olet · About LEMON Manuals