LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Door Inside Handle Bezel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Inside Pull Handle Bezel Assembly
    GM1429709Courtesy of GENERAL MOTORS CORP.
  1. Position the replacement pull handle bezel assembly to the door trim panel.
  2. Place the door trim panel, back-side up, on a clean prepared non-abrasive surface.
    3. NOTE: Refer to Fastener Notice .
  3. Install the 2 screws (2).

    Tighten:  Tighten the screws to 2.8 N.m (25 lb in).

  4. Use clamps to temporarily secure handle bezel to door trim panel.
  5. Using a Weller model 8200 soldering gun, or equivalent, equipped with a flat tip, heat and bend the tabs (1) securing the handle bezel to the door panel.
  6. Heat the tabs (4) securing the handle bezel to the door panel.
    7. IMPORTANT: A desirable round heat-stake weld should have an approximate diameter of 13 mm (1/2 in) and height 2 mm (3/32 in).
  7. Use a soldering gun equipped with a flat tip. Using a circular motion, apply firm steady pressure to spread the heat-stake (3) material into the door trim panel to achieve a proper weld.
  8. Allow for heat-stakes to cool and remove clamps.
  9. Verify that the pull handle bezel is securely heat-staked to the door trim panel.
  10. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement  or Rear Side Door Trim Panel Replacement .
scientia non olet · About LEMON Manuals