LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Center Pillar Upper Garnish Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pillar Upper Garnish
    GM1453838Courtesy of GENERAL MOTORS CORP.
  1. Position the center pillar upper garnish (1) to the center pillar.
  2. Feed the seat belt through the opening in the center pillar garnish (1).
  3. Align the garnish molding clips to the center pillar.
  4. Push the center pillar upper garnish (1) towards the body to engage the clips.
    5. Fig 2: Rear Seat Belt Lower Anchor
    GM1453842Courtesy of GENERAL MOTORS CORP.
  5. Install the rear seat belt lower anchor bolt (1). Refer to Seat Belt Retractor Replacement - No. 1 Rear .
  6. Install the endgate center molding. Refer to Endgate Center Molding Replacement .
scientia non olet · About LEMON Manuals