LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Body Side Trim Panel Replacement - Right Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Electrical Connector, Door Lock Switch & CPA Pin
    GM833504Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear pillar trim panel.
  2. Remove the inflator nozzle retaining nut.
  3. Remove the inflator bezel.
  4. Remove the inflator switch from the bezel.
  5. Using a suitable flat bladed tool, press downward on the door lock switch and rotate the top of the switch outward to disengage the switch from the trim panel.
  6. Remove the connector position assurance (CPA) pin and remove the electrical connector from the switch.
    7. Fig 2: Inflator Nozzle
    GM833506Courtesy of GENERAL MOTORS CORP.
  7. Remove the lift gate sill plate. Refer to Liftgate Door Sill Plate Replacement .
  8. Remove the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  9. Firmly grasp and gently pull up on the body side panel tray to disengage it from the body panel.
  10. Disconnect the 12 volt power supply electrical connector.
  11. Remove the inflator nozzle from the panel.
    12. Fig 3: Right Side Body Trim Panel
    GM833490Courtesy of GENERAL MOTORS CORP.
  12. Firmly gasp and gently pull the front edge of the body panel to disengage the retaining clips.
  13. Remove the right side body panel from the vehicle.
  14. Inspect and replace any missing or broken retaining clips.
scientia non olet · About LEMON Manuals