LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Body Side Trim Panel Replacement - Left Side >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Body Side Trim Panel
    GM833494Courtesy of GENERAL MOTORS CORP.
  1. Remove the spare tire carrier. Refer to Spare Tire Carrier Replacement .
  2. Remove the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  3. Remove the liftgate sill plate. Refer to Liftgate Door Sill Plate Replacement .
  4. Remove the rear pillar garnish panel. Refer to Rear Upper Garnish Molding Replacement .
  5. Firmly grasp the front edge of the left body side panel and gently pull to disengage the retaining clips.
  6. Remove the left body side panel from the vehicle.
scientia non olet · About LEMON Manuals