LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Body Side Trim Panel Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Body Side Trim Panel
    GM833494Courtesy of GENERAL MOTORS CORP.
  1. Install the left body side panel to the vehicle.
  2. Align the retaining clips with the opening in the body and gently press to fully seat the retaining clips.
  3. Install the rear pillar garnish panel. Refer to Rear Upper Garnish Molding Replacement .
  4. Install the liftgate sill plate. Refer to Liftgate Door Sill Plate Replacement .
  5. Install the lock pillar trim panel. Refer to Body Lock Pillar Trim Panel Replacement .
  6. Install the spare tire carrier. Refer to Spare Tire Carrier Replacement .
scientia non olet · About LEMON Manuals