LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Body Lock Pillar Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lock Pillar Trim Panel
    GM833512Courtesy of GENERAL MOTORS CORP.
  1. Fold the rear seat No. 1 forward to access the seat belt bolt.
  2. Remove the seat belt to floor mounting bolt.
  3. Remove the vehicle jack and bracket, if necessary.
  4. Firmly grasp and gently pull the lock pillar to disengage the retaining clips.
  5. Feed the seat belt through the opening in the lock pillar trim panel.
  6. Remove the lock pillar trim panel from the vehicle.
  7. Inspect for broken or missing retaining clips and replace as necessary.
scientia non olet · About LEMON Manuals