LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Body Lock Pillar Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lock Pillar Trim Panel
    GM833512Courtesy of GENERAL MOTORS CORP.
  1. Install the lock pillar trim panel to the vehicle.
  2. Feed the seat belt through the opening in the lock pillar trim panel.
  3. Align the retaining clips with the openings in the body.
  4. Gently press to fully seat the retaining clips.
    5. NOTE: Refer to Fastener Notice .
  5. Install the vehicle jack and bracket if necessary.
  6. Raise the jack after it is installed in the bracket to ensure that it is secure.

    Tighten:  Tighten the bracket to 53 N.m (39 lb ft).

  7. Install the seat belt to floor mounting bolt.
  8. Fold the rear seat into the upright position.
scientia non olet · About LEMON Manuals