LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Body Hinge Pillar Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove close out panel at the top of the hinged pillar trim panel using a small flat bladed tool.
  2. Remove the retaining screw.
    3. Fig 1: Hinge Pillar Trim
    GM833515Courtesy of GENERAL MOTORS CORP.
  3. Firmly grasp and gently pull to disengage the retaining clips.
  4. Disconnect the lower lamp wire connector.
  5. Remove the hinge pillar trim from the vehicle.
  6. Inspect for broken or missing retaining clips and replace as necessary.
scientia non olet · About LEMON Manuals