LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Interior Trim And Paneling) >> Repair Instructions >> Body Hinge Pillar Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hinge Pillar Trim
    GM833515Courtesy of GENERAL MOTORS CORP.
  1. Install the hinge pillar trim to the vehicle.
  2. Connect the lower lamp wire connector.
  3. Align the locator pins and the retaining clips to the opening in the body.
  4. Gently press to fully seat the retaining clips.
  5. Install the retaining screw.
  6. Install the close out panel.
scientia non olet · About LEMON Manuals