LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Cooling) >> Repair Instructions >> Surge Tank Hose/Pipe Replacement - Outlet >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Draining and Filling Cooling System .
  2. Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
    3. Fig 1: Identifying Heater Hose To Heater Core Fittings
    GM362171Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the heater hose quick connect fitting.
    1. Using the J 43181  disconnect the inlet heater hose from the heater core. See Special Tools .
    2. Install the J 43181  to the heater core outlet pipe. See Special Tools .
    3. Close the tool around the heater core outlet pipe.
    4. Firmly pull the tool into the quick connect end of the heater hose.
    5. Firmly grasp the heater hose. Pull the heater hose forward in order to disengage the hose from the heater core.
    4. Fig 2: Heater Hose & Mounting Clip
    GM814572Courtesy of GENERAL MOTORS CORP.
  4. Remove the heater hose (3) from the mounting clip (2).
    5. Fig 3: Surge Tank Hose & Engine (Outlet)
    GM814578Courtesy of GENERAL MOTORS CORP.
  5. Reposition the surge tank outlet hose clamp (3) from the engine (2).
  6. Remove the surge tank outlet hose (6) from the engine (2).
    7. Fig 4: Surge Tank Components
    GM801110Courtesy of GENERAL MOTORS CORP.
  7. Reposition the surge tank outlet hose clamp (5) from the surge tank (2).
  8. Remove the surge tank outlet hose (3) from the surge tank (2).
  9. Remove the surge tank outlet hose (3) from the vehicle.
scientia non olet · About LEMON Manuals