LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Cooling) >> Repair Instructions >> Radiator Inlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Draining and Filling Cooling System .
  2. Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
    3. Fig 1: Radiator Hose & Engine (Inlet)
    GM814579Courtesy of GENERAL MOTORS CORP.
  3. Reposition the radiator inlet hose clamp (3) from the engine (1).
  4. Remove the radiator inlet hose (2) from the engine (1).
  5. Remove the radiator inlet hose (4) from the mounting clip (3).
    6. Fig 2: Radiator Hose & Radiator (Inlet)
    GM801113Courtesy of GENERAL MOTORS CORP.
  6. Reposition the radiator inlet hose clamp (5) from the radiator (6).
  7. Remove the radiator inlet hose (4) from the radiator (6).
  8. Remove the inlet hose from the vehicle.
scientia non olet · About LEMON Manuals