LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Cooling) >> Repair Instructions >> Engine Coolant Thermostat Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump Inlet
    GM370076Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the thermostat housing to the water pump.
  2. Install the thermostat housing bolts.

    Tighten:  Tighten the bolts to 15 N.m (11 lb ft).

  3. Install the radiator outlet hose.
    4. Fig 2: MAF/IAT Sensor & Air Cleaner Assembly
    GM832908Courtesy of GENERAL MOTORS CORP.
  4. Install the air cleaner outlet duct.
  5. Install the air cleaner outlet duct clamps at the throttle body and at the Mass airflow (MAF) sensor.

    Tighten:  Tighten the air cleaner outlet duct clamp screws to 7 N.m (62 lb in).

  6. Fill the cooling system. Refer to Draining and Filling Cooling System .
scientia non olet · About LEMON Manuals