LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Cooling) >> Repair Instructions >> Coolant Air Bleed Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to Draining and Filling Cooling System .
    2. Fig 1: View Of Coolant Air Bleed Hose & Throttle Body
    GM846664Courtesy of GENERAL MOTORS CORP.
  2. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) .
  3. Remove the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  4. Reposition the coolant air bleed hose clamp at the throttle body.
  5. Remove the coolant air bleed hose from the throttle body.
    6. Fig 2: Coolant Air Bleed Hose & Pipe
    GM790766Courtesy of GENERAL MOTORS CORP.
  6. Reposition the hose clamp at the pipe.
  7. Remove the coolant air bleed hose (1) from the pipe (2).
  8. Remove the coolant air bleed hose from the vehicle.
scientia non olet · About LEMON Manuals