LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine Cooling) >> Repair Instructions >> Coolant Air Bleed Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Coolant Air Bleed Hose & Pipe
    GM790766Courtesy of GENERAL MOTORS CORP.
  1. Install the coolant air bleed hose (1) to the pipe (2).
  2. Position the hose clamp at the pipe.
    3. Fig 2: View Of Coolant Air Bleed Hose & Throttle Body
    GM846664Courtesy of GENERAL MOTORS CORP.
  3. Install the coolant air bleed hose to the throttle body.
  4. Position the coolant air bleed hose clamp at the throttle body.
  5. Install the air cleaner resonator outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  6. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) .
  7. Add engine coolant, if necessary.
scientia non olet · About LEMON Manuals