LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Engine Controls And Fuel - 6.0L - DTC P0455 To DTC U0107) >> DTC P0506 (With Throttle Actuator Control) >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This test determines if the engine can achieve the commanded RPM.
DTC P0506 (With Throttle Actuator Control)

Step Action Yes No
Schematic Reference: Engine Controls Schematics
Connector End View Reference: Engine Controls Component Views or Powertrain Control Module Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Apply the park brake.
  2. Block the drive wheels.
  3. Start the engine.
  4. Turn OFF all accessories.
  5. Command the engine RPM to 1,500 RPM, to 500 RPM, and back to 1,500 RPM with the RPM control function of the scan tool.
  6. Exit the RPM Control function.
Did the engine speed stay within 100 RPM of the commanded RPM during the above test?		 Go to Step 3  Go to Step 4 
3
  1. Observe the Freeze Frame/Failure Records for this DTC.
  2. Turn OFF the ignition for 30 seconds.
  3. Use the following information to operate the vehicle under the conditions which set the DTC:
    • The data in the Freeze Frame/Failure Records
    • The parameters listed in the Conditions for Running in the DTC
Does the DTC set?		 Go to Step 4  Go to Testing for Intermittent Conditions and Poor Connections
4 Inspect for the following conditions:
  • Deposits in the throttle body
  • Objects which are blocking the air intake system
  • Energy-draining load on the engine, such as transmission conditions

Did you find and correct the condition?		 Go to Step 5  -
5
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Did the DTC fail this ignition?		 Go to Step 2  Go to Step 6 
6 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals