LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 544 (Wiring Systems And Power Management - Description And Operation) >> Description and Operation >> Retained Accessory Power Description and Operation >> Serial Data Control of Retained Accessory Power (RAP)

Serial Data Control of Retained Accessory Power (RAP)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

RAP systems controlled by serial data are as follows:

Power Windows 

Window RAP activation/termination timing is the same as relay operation. The front window switches are separate modules that operate the windows on their respective side of the vehicle.

Vehicle Communication Interface Module (VCIM) (Onstar®) 

VCIM RAP activation/termination is the same as radio operation with 1 exception; if there is an active call when the ignition key is turned off the VCIM will remain in RAP mode and keep the radio in RAP mode until the call is terminated.

Radio 

Radio RAP activation/termination is the same as relay operation with 1 exception; the only door switch that will turn off the radio during RAP is the driver door open switch.