Drive Motor with Generator Assembly Removal - 2nd Position

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Drive Motor with Generator Assembly - 2nd Position

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Generator Drive Motor Bolt M6 x 1.0 x 20.0 (Qty: 3) NOTE: Remove only the three bolts on the motor that are indicated.
2	Drive Motor (w/Generator) Assembly - 2nd Position WARNING: The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly. CAUTION: Set drive generator motor on its side to avoid damaging the electrical connectors. NOTE: Ensure the DT-48473 motor lift plate is completely seated and locked on the motor assembly and ensure legs are bolted tight. It will require the use of an overhead chain fall to remove. The O-Ring seals are not reusable. Special Tools DT-48473 Motor Lift Plate

Callout

Component Name

Generator Drive Motor Bolt M6 x 1.0 x 20.0 (Qty: 3)

NOTE:

Remove only the three bolts on the motor that are indicated.

Drive Motor (w/Generator) Assembly - 2nd Position

WARNING:

The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.

CAUTION:

Set drive generator motor on its side to avoid damaging the electrical connectors.

NOTE:

Ensure the DT-48473 motor lift plate is completely seated and locked on the motor assembly and ensure legs are bolted tight. It will require the use of an overhead chain fall to remove. The O-Ring seals are not reusable.

Special Tools
DT-48473 Motor Lift Plate