LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 542 (Automatic Transmission - 2ML70 - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Drive Motor with Generator Assembly Installation - 2nd Position

Drive Motor with Generator Assembly Installation - 2nd Position

WARNING: This page is about a different car, the 2012 GMC Yukon, 2012 Chevrolet Tahoe, and 2012 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Drive Motor with Generator Assembly - 2nd Position
GM1867787Courtesy of GENERAL MOTORS COMPANY
Drive Motor with Generator Assembly Installation - 2nd Position

Callout Component Name
1 Drive Motor (w/Generator) Assembly - 2nd Position
WARNING:

The generator motor weighs approximately 36 kg (80 lbs). Personal injury may result if you lift the generator motor improperly.

CAUTION:

Carefully feed temp sensor and resolver connector thru case opening or damage may occur.

NOTE:

Install NEW O-Rings on motor while using holding fixture.
2 Generator Drive Motor Bolt M6 x 1.0 x 20 (Qty: 3)
CAUTION:

Refer to Fastener Caution .

NOTE:

Use Dexron VI to aid with installation on O-Rings for motor.


Tighten 
9-13 (80-115 lb in)
Special Tools 
DT-48473  Motor Lift Plate
scientia non olet · About LEMON Manuals