Control Valve Body Assembly Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Control Valve Body Assembly Component View

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	NEW Fluid Pump Seal Assembly
2	NEW Fluid Pump Seal Assembly
3	NEW Center Support Fluid Passage Seal Assembly TIP: There are two different designs for the Center Support Fluid Passage Seal. The design for 6L45/50 (MYA/MYB) models utilizes tabs. The design for 6L80/90 (MYC/MYD) models does not have tabs.
4	Control Valve Body Assembly CAUTION: The control valve body assembly needs to be lowered into place vertically, with no lateral movement. Lateral movement can damage the pass through connector pins and/or the oil transfer seals. TIP: Align the manual shift shaft position switch activator slide with the detent lever guide pin.
5	Bolts M5 x 73 (Qty: 6) CAUTION: Refer to Fastener Caution . Procedure Tighten in the sequence shown. Tighten 8 N.m (71 lb in). Special Tool DT-48285 Valve Body Torx Plus Socket (if applicable) For equivalent regional tools, refer to Special Tools .